msp430f5529簡單uart源程序(用串口助手發什么回復什么)

ID:375422 · 發表于 2018-7-20 09:18

單片機源程序如下：

/*****用串口助手發什么回復什么****/
#include "msp430f5529.h"
// ACLK = REFO = 32768Hz, MCLK = SMCLK = default DCO/2 = 1048576Hz
// P3.4，5——USCI_A0 TXD/RXD；P9.4,5——USCI_A2 TXD/RXD；P10.4,5——USCI_A3 TXD/RXD；
void main(void)
{
WDTCTL = WDTPW + WDTHOLD; // Stop WDT
P4SEL |=BIT4+BIT5 ; // P5.6,7 = USCI_A1 TXD/RXD
UCA1CTL1 |= UCSWRST; // **Put state machine in reset**
UCA1CTL1 |= UCSSEL_2; // SMCLK
UCA1BR0 = 9; // 1MHz 115200 (see User's Guide)
UCA1BR1 = 0; // 1MHz 115200
UCA1MCTL |= UCBRS_1 + UCBRF_0; // Modulation UCBRSx=1, UCBRFx=0
UCA1CTL1 &= ~UCSWRST; // **Initialize USCI state machine**
UCA1IE |= UCRXIE; // Enable USCI_A1 RX interrupt
__bis_SR_register(LPM0_bits + GIE); // Enter LPM0, interrupts enabled
}
// Echo back RXed character, confirm TX buffer is ready first，發送數據之前確定發送緩存準備好
#pragma vector=USCI_A1_VECTOR
__interrupt void USCI_A1_ISR(void)
{
switch(__even_in_range(UCA1IV,4))
{
case 0:break; // Vector 0 - no interrupt
case 2: // Vector 2 - RXIFG
while (!(UCA1IFG&UCTXIFG)); // USCI_A1 TX buffer ready? UCTXIFG(USCI Transmit Interrupt Flag)
//等待數據發送完成完成UCTXIFG置1 跳出循環
UCA1TXBUF = UCA1RXBUF; // TX -> RXed character
break;
case 4:break; // Vector 4 - TXIFG
default: break;
}
}
// UCTXIFG=0x02，UCA1IFG&UCTXIFG，當UCA1IFG的UCTXIFG位為1時，說明UCA1TXBUF為空，
//跳出while循環循環；當UCTXIFG位為0時UCA1TXBUF不為空，停在循環。